Based in Gregory Hills NSW

Concrete re-sealing
in Gregory Hills.

Based in Gregory Hills, our team can assess whether your existing driveway finish is ready for re-sealing. If the coat applied when your home was finished has faded or worn through in the wheel tracks, the condition of that original sealer is the starting point.

Get a quote

What re-sealing covers

Protection that wore off, put back.

Sealer is a coating, and coatings wear. Cars, foot traffic and weather slowly thin it until concrete starts absorbing oil, water and dirt again, and colour looks flat. Re-sealing restores that protective layer on concrete that has been sealed before.

It can be a clear re-seal to bring back depth, or a colour re-seal to even out a faded or patchy finish. Either way, the result depends on preparation: the surface needs to be cleaned, any failing sealer dealt with, and the slab fully dry before a new coat goes down.

Re-sealing is not a crack repair or a resurface. If we see something beyond re-sealing, we will tell you plainly.

A common Gregory Hills enquiry

When the first builder-applied seal starts to fade

A first coat applied at handover often wears unevenly: it holds up near the garage and along the edges, then thins where tyres turn and stop. Re-sealing at that point is usually about restoring an even finish across the whole slab, not just patching the worn strip. We look at whether the existing sealer is still bonded, what type it appears to be, and whether a clean is enough to prepare it or whether loose, flaking sealer needs to come off first.

Preparation decisions we talk through

  1. 01Check whether the original sealer is still well bonded or is lifting and flaking
  2. 02Wheel-track wear versus overall fading changes how much preparation is needed
  3. 03Matching a coloured finish so new and existing areas read as one surface
  4. 04Leaving the slab clean and fully dry before any sealer goes down

Our sealing work.

Examples of All Pro Concrete Group work. These photos are not from Gregory Hills specifically.

Before and after example of an All Pro driveway: stained grey concrete cleaned and sealed to an even charcoal finish
Example of our work: before and after sealing
Example of All Pro work: Sealed charcoal driveway at a grey brick home
Sealed charcoal driveway at a grey brick home
Example of All Pro work: Sealed driveway at a rendered tan home
Sealed driveway at a rendered tan home

Gregory Hills questions.

My driveway was sealed when the house was built. Can it be re-sealed?
Usually, yes. The first step is checking how well the existing coat is holding. Send photos of the worn areas and the areas still in good condition so we can compare.
Should I re-seal only the worn parts?
Spot re-sealing often leaves visible patches. In most cases treating the full surface gives a more even result, but we will talk through the options once we see it.
You are based in Gregory Hills. Does that change how I enquire?
No. Every enquiry starts the same way: use Get a quote, answer four quick questions, then book a time with Sam.

Start your quote.
Get a straight answer.

Answer four quick questions about your Gregory Hills concrete, then pick a time with Sam from the booking calendar. Have photos of the surface and any worn or peeling areas handy to talk through.

Re-sealing nearby.

Other areas: